Good Quality Weipro PH2010A PH Meter And Controller PH Online Monitor

Power?3W
PH test range: 0-14PH
PH control range: 0-14PH

Category:

Description

Description?
This product will have to be used with a carbon dioxide cylinder with a solenoid valve or other carbon dioxide system.
Product Features:
This product has a long-term detection of aquarium PH value, when the PH value is higher than the set value, the automatic power supply for other equipment, such as CO2 solenoid valve connected to start out the supply of CO2 equipment. When the aquarium PH value reaches the set value routinely bring to an end the power.
Instructions to be used:
1. Connect the power supply AC 220V-50 / 60HZ.
2. Insert the PH electrode into the input.
3. Set PH SET to PH, place PH electrode in PH7 calibration fluid, wait a couple of seconds for the display to stabilize, and adjust the CAL PH7 knob with the supplied plastic “one-letter” screwdriver to make the displayed value 7.00.
4. Eliminate the PH electrode from the PH7 calibration solution and place the PH electrode within the water to be tested.
5. Set the PH SET to “SET” position, adjust the SET knob until the required PH value is displayed. In most cases speaking, the pH value of the aquatic tank is PH6.8-PH7.2, the PH value of the marine tank Between pH 8.0 and pH 8.4, the carbon dioxide system plug is plugged into the controller socket, and the controller can use the carbon dioxide released by the carbon dioxide system to lower the pH.
Power?3W
PH test range: 0-14PH
PH keep an eye on range: 0-14PH
PH resolution: 0.01 PH
PH accuracy: 0.01PH
Host size: 8 cm wide, 14 cm high, 3.8 cm thick
Package included?
1 x PH controller

Power?3W
PH test range: 0-14PH
PH keep an eye on range: 0-14PH
Host size: 8 cm wide, 14 cm high, 3.8 cm thick

Reviews

There are no reviews yet.

Be the first to review “Good Quality Weipro PH2010A PH Meter And Controller PH Online Monitor”

Your email address will not be published. Required fields are marked *